Advice / Gas
Gas compliance certificates and compliance plates in Queensland
When a gasfitter finishes installing a gas system in Queensland, they must give the owner a gas system compliance certificate, issued through the RSHQ Portal. If the system is supplied from a gas network, a copy also goes to the network operator within 5 days. Since July 2025 most installations no longer need a physical compliance plate; caravans are the exception.
The certificate is the proof
A compliance certificate is the installer's signed statement that the gas system meets the rules. The Queensland Government's page for gas work licence holders sets out the sequence. On completion the gasfitter issues the owner or operator with an original copy of the gas system compliance certificate. Where the system takes fuel gas from a distribution system or fuel gas network, the certificate is also given to that system's operator, and the obligations page gives the deadline as within 5 days.
Gasfitters do not write these on a carbon pad any more. The same page says licence holders must use the RSHQ Portal to submit compliance certificates and defect notices. RSHQ is Resources Safety and Health Queensland, the regulator that houses the Petroleum and Gas Inspectorate.
Keep your copy with the house papers. A buyer's solicitor, an insurer or the next gasfitter may ask for it, and it names the licence holder who did the work.
What happened to the plate
For years a Queensland gas installation was expected to carry a small metal compliance plate, often inside the meter box or a kitchen cupboard. The Queensland Government page records that the requirements for gas compliance plates changed in July 2025. Most installations no longer require a physical plate. Caravans are the stated exception.
Two practical consequences follow. An installation done before the change may have a plate and that is fine. An installation done after it may have no plate at all, so the absence of one on a new cooktop connection is not, on its face, a sign of shoddy work. Ask for the certificate instead.
Defect notices
If a gas work licence holder has safety concerns about a gas system, they must give the owner or operator a defect notice. Where there is an imminent risk of material harm they must also act to avoid, eliminate or minimise the risk and report it immediately to the network operator and the Petroleum and Gas Inspectorate. No notice is needed if the concern is fixed on the spot.
So a gasfitter who turns off and tags your heater is following a legal duty. The notice should say what is wrong; get the repair quoted from that.
Before the job starts
There is a step that owners rarely see. Before installing a new gas system, or adding appliances that raise demand by 100 MJ/hour or more on a metered distribution system, the licence holder must advise the network operator. They also have to confirm the supply can meet the extra demand, which means checking meter capacity, pipe sizing and, for LPG, cylinder storage and vaporisation rate. This is why a gasfitter quoting for a big continuous flow hot water unit may want to look at your meter and pipe run first.
Who is allowed to do the work
The Queensland Government's gas safety page says only a licensed gasfitter can carry out gas work, which includes installing, repairing, servicing, testing or certifying gas systems, and tells householders to ask to see the person's gas work licence before they start. That gas work licence comes from the gas regulator. The QBCC Gasfitting contractor licence listed on this site is the business licence that sits on top of it.
Short answers
I had a gas cooktop connected and there is no compliance plate. Is that a problem?
Not necessarily. The Queensland Government states that plate requirements changed in July 2025 and most installations no longer need a physical plate, apart from caravans. You should still have been given a gas system compliance certificate.
Who sends the certificate to the gas network?
The gas work licence holder. The Queensland Government's obligations page says a copy goes to the network operator within 5 days of completion.
Do caravans and vehicles get a different document?
For gas fuel systems in a vehicle, vessel or stationary engine, the licence holder issues a gas system inspection certificate to the owner or operator after inspecting, altering or installing any part of the system.
Sources
- Queensland Government: Gas certificates, plates and notices
- Queensland Government: Gas work licence and authorisation holder obligations
- Queensland Government: Using natural gas and LPG safely
- QBCC: Gasfitting licence class
Written by the Plumber & Gasfitter editorial desk from the sources listed, all read in November 2026. This is general information for Queensland and not legal advice. Rules change; the linked regulator pages are the authority.