Plumber & GasfitterRegister of licensed contractors

Advice / Plumbing

Choosing a hot water system, and the tempering valve rule

Any new or replacement hot water system in a Queensland home must have a temperature control device. The Queensland Government's rule is that storage systems heat water to at least 60°C, and the device limits what reaches the taps to a maximum of 50°C. Replacing a water heater is notifiable work, so your plumber lodges a Form 4 with QBCC.

Why two temperatures

The tank has to be hot and the tap has to be safe, and those two needs pull in opposite directions. Business Queensland explains that residential storage systems must heat water to a minimum of 60°C to prevent the growth of bacteria such as Legionella. Water at that temperature scalds, so a temperature control device sits on the outlet side and delivers water to taps at no more than 50°C.

The most common device in a house is a tempering valve, a small brass mixing valve near the heater. QBCC's home owner guide names a second type, the thermostatic mixing valve (TMV), and says a TMV must be serviced by a licensed plumber who also holds the appropriate endorsement. Tempering valves need servicing too, in line with the manufacturer's instructions. A valve that has drifted is the usual reason a shower slowly goes lukewarm.

What gets upgraded when the old unit dies

People are often surprised that a like-for-like swap costs more than the heater itself. QBCC's guide is direct about why: whenever a hot water system is replaced or a new one installed, the law requires the installation to be brought up to standard. That may include fitting the temperature control device, correct lagging on the pipes and a proper termination point for the overflow. If your old electric unit predates these rules, expect the quote to list those items.

Choosing the type

The main choices are an electric storage tank, a gas storage tank, a gas continuous flow unit, a solar system with a booster, or a heat pump. The right pick depends on what energy you already have at the house, roof space and how many people shower in a row. Three licensing points narrow the field of installers:

  • Solar and heat pump units. Business Queensland states that solar hot water and heat pump hot water systems must be installed by a hot water installer with a solar and heat pump endorsement from QBCC. The guide says the endorsement is printed on the reverse of the plumber's occupational licence card, so ask to see it.
  • Gas units. The gas connection is gas work. The business you hire needs the Gasfitting contractor class as well as Plumbing and Drainage, or it must bring in a gasfitter. Our suburb lists show who holds both.
  • Any unit. QBCC lists installing or replacing water heaters, including electric, gas, solar or heat pumps, as an example of notifiable work.

Looking after it

QBCC's guide says it is generally recommended that hot water systems be serviced every five years by an appropriately licensed person, and more often where the water comes from a bore or a rainwater tank. Owners and tenants can operate the temperature pressure-relief valve themselves at regular intervals, taking care to avoid scalding and to close the valve properly afterwards. If you have solar with a booster, the guide advises keeping the booster on and working during periods of low sun so the stored water still reaches 60°C.

Short answers

Can I ask the plumber to leave the tempering valve off so the water is hotter?

No. Business Queensland states that a temperature control device must be fitted to all new and replacement hot water systems, with delivery to taps at a maximum of 50°C.

Does a replacement hot water system need a council permit?

Not usually. QBCC classes installing or replacing a water heater as notifiable work, which is done without a local government permit. The plumber registers it with QBCC on a Form 4 and gives you a copy.

Who can service a thermostatic mixing valve?

QBCC's home owner guide says a TMV must be serviced by a licensed plumber who also holds the appropriate endorsement. QBCC lists a thermostatic mixing valve endorsement for testing, commissioning and maintaining these valves.

Sources

Written by the Plumber & Gasfitter editorial desk from the sources listed, all read in November 2026. This is general information for Queensland and not legal advice. Rules change; the linked regulator pages are the authority.

Related guides